ASTM F still includes a performance requirement that the rainwear material shall be flame resistant and shall not melt or drip when tested in accordance with ASTM D and shall exhibit no more than a second afterflame time and less than a char lengthSo, if your FR rainwear complies with ASTM F, it still complies with ASTM D.

Where a fire sprinkler system in accordance with Section P is not provided, the common wall shall be not less than a hour fire resistance rated wall assembly tested in accordance with ASTM E, UL or Section of the International Building Code.

"Fire resistance." Steel supports or exposed piling shall be protected by materials having a fire resistance rating of not less than hours, except that steel saddles need not be protected if less than inches high at their lowest pointWater spray protection or its equivalent may be used in lieu of fire resistive materials to protect supports.

Performance requirements of ASTM F are as follows Flame Resistance Rainwear material shall be flame resistant and shall not melt and drip when tested in accordance with ASTM D DM and shall exhibit no more than a second afterflame time and less than a char lengthThermal Protection Rainwear material shall be tested in

Steel supports or exposed piling shall be protected by materials having a fire resistance rating of not less than hours, except that steel saddles need not be protected if less than inches (cm) high at their lowest point.

Cables used for survivability of required critical circuits shall be listed in accordance with UL and shall have a fire resistance rating of not less than hoursElectrical circuit protective systems shall have a fire resistance rating of not less than hours.

Flame Resistant Paint w Firefree Cost Efficient Fully Tested Protection.

Fire partitions shall have a fireresistance rating of not less than hourExceptions Corridor walls permitted to have a hour fireresistance rating by Table Dwelling unit and sleeping unit separations in buildings of Type IIB, IIIB and VB construction shall have fireresistance ratings of not less than hour in

The building elements shall have a fire resistance rating not less than that specified in Table and exterior walls shall have a fire resistance rating not less than that specified in Table Where required to have a fire resistance rating by Table , building elements shall comply with the applicable provisions of Section .

Commonly used fire resistant coolants include a fire point of not less than °C shall be permitted to be installed in accordance with .(A) or .(B

Fire Separations () Except as permitted by Sentence (), the seating area of a Group A, Division occupancy shall be separated from adjacent occupancies in the floor area by a fire separation having a fire resistance rating not less than h if the occupant load in the seating area exceeds .

Tile fasteners shall be corrosion resistant and not less than gage, inch ( mm) head, and of sufficient length to penetrate the deck not less than inch ( mm) or through the thickness of the deck, whichever is lessAttaching wire for clay or concrete tile shall not be smaller than inch ( mm).

(iii)(A) Appendages and projections Unenclosed accessory structures attached to buildings with habitable spaces and projections, such as decks, shall not be less than one hour fire resistance rated construction, heavy timber construction, or constructed of one of the following